You need to measure physico-chemical properties of your products: in its laboratories, Processium has developed for more than 15 years an expertise for the measurement of physico-chemical properties. Moreover, Processium is able to provide expertise around these particular measurements:

Regulatory issues:

  • Melting point
  • Boiling point
  • Vapour pressure
  • Density
  • Surface tension
  • Water Solubility
  • Octanol-water partition coefficient
  • Flash point
  • Auto-ignition temperature

Process equipment sizing:

  • Melting and boiling points
  • Heat of phase transition
  • Vapour pressure
  • Density
  • Surface or interfacial tension
  • Viscosity, rheological behaviour
  • Heat capacity
  • Thermal conductivity
  • Solubility
  • Solvent-water partition coefficient
  • Specific surface
  • Particle size distribution

You need to identify and/or quantify your products: in its laboratories, Processium has developed for more than 15 years an expertise for the analysis of products. Moreover, Processium is able to develop reliable analysis methodologies like for example:

  • To identify and to quantify trace products (below 100 ppb),
  • To quantify pollutants in a gas like propellant,
  • To deal with unstable products like peroxides,
  • To quantify VOC or toxic products in a workshop,
  • To identify and quantify volatile products issued from a unexpected reaction into a newly developed process,
  • To quantify gases and gas-liquid mixtures under pressure (up to 100 bars).

Processium also supports the development of quality control procedure by the implementation of analytical procedures and reliable measurement methodologies that provide reproducible results.

Our Case Studies

  • Salts solubility in water
  • Vapour pressure of various effluents at 25°C or 50°C
  • Vapour pressure of UV cross-linkable liquids
  • Measurements of heat capacity of brines or strong acid solutions close to 95°C
  • Density measurements of mixtures under pressure up to 200°C
  • Ageing tests on polymeric materials
  • Ageing tests on miscellaneous stainless steel and aluminium under high temperatures and presence of solvents
  • Deactivation test on catalysts
  • Effluent sedimentation rate measurement
  • Thermal stability of mass reaction following an incident on industrial unit
  • Density, heat capacity, viscosity, thermal conductivity on heat transfer fluids up to 250°C
  • Determination of rheological profile of gels
  • Octanol-water partition coefficient of polymers
  • Solubility of pressurized liquid in water in the REACH context
  • Very low solubility measurements (around 100 ppb)
  • Measurements of granulometry and specific surface of porous materials
  • Determination of lower heat capacity and curves of distillation for fuels
  • Screening of adsorbent materials for pollutant removal

Our Equipment

Should you need any additional information on our offer, do not hesitate to contact us