Physico-chemical Properties Measurements

You have the products and need physico-chemical characterization for regulatory or process purpose; in its laboratories, Processium has an expertise for the measurement of these properties and is able to develop reliable measurement methodologies to provide reproducible results on miscellaneous physico-chemical properties.

Moreover, Processium is able to provide process expertise around these measurements.

Regulatory issues:

  • Melting point
  • Boiling point
  • Vapour pressure
  • Density
  • Surface tension
  • Water Solubility
  • Octanol-water partition coefficient
  • Flash point
  • Auto-ignition temperature

Process equipment sizing:

  • Melting and boiling points
  • Heat of phase transition
  • Vapour pressure
  • Density
  • Surface or interfacial tension
  • Viscosity, rheological behaviour
  • Heat capacity
  • Thermal conductivity
  • Solubility
  • Solvent-water partition coefficient
  • Specific surface
  • Particle size distribution

Processium can also perform stability test on various type of products with dedicated methodologies adapted to each specific need.

Processium also develops specific devices to be able to study ageing of your products together with the identification and quantification of decomposition by-products. This method can be adapted for either static or dynamic mode should you need to simulate life cycle of your products. Same devices can be also used to study corrosion aspects linked to the use of your products.

Our Case Studies

  • Salts solubility in water
  • Bubble temperature of oils at 10-4 mbar
  • Vapour pressure of various effluents at 25°C or 50°C
  • Vapour pressure of petroleum cuts from -40 to 300°C
  • Vapour pressure of UV cross-linkable liquids
  • Measurements of heat capacity of brines or strong acid solutions close to 95°C
  • Density measurements of mixtures under pressure up to 200°C
  • Ageing tests on polymeric materials
  • Ageing tests on miscellaneous stainless steel and aluminium under high temperatures and presence of solvents
  • Deactivation test on catalysts
  • Effluent sedimentation rate measurement
  • Thermal stability of mass reaction following an incident on industrial unit
  • Density, heat capacity, viscosity, thermal conductivity on heat transfer fluids up to 250°C
  • Determination of rheological profile of gels
  • Octanol-water partition coefficient of polymers
  • Solubility of pressurized liquid in water in the REACH context
  • Very low solubility measurements (around 100 ppb)
  • Measurements of granulometry and specific surface of porous materials
  • Determination of lower heat capacity and curves of distillation for fuels
  • Screening of adsorbent materials for pollutant removal

Our Equipment

Should you need any additional information on our offer, do not hesitate to contact us